Triggers are not running in 0.6 after installation

[simonarbel]

Hi

Customer installed 0.6 few weeks ago with managed exports.
After the installation ended., customer waited for some time and noticed there were no pipelines runs showing in the DF studio. We have also noticed the 4 triggers are not in "stated" status and when activating them they go back to "stopped" status.
We decided to configure manual exports instead (after removing the scopes in the settings.json file) but that didn't seem to fix the issue.
CSV files were created and presented in the container under:
msexports/billingAccounts/XXXX/62732052/finopshub-focus-cost/20231101-20241130/202412052106/xxxx-xxxx-xxxxx-xxxxx

Can anyone explain what is the cause for this and how to resolve?

Thank you

[MSBrett]

If you open up data factory are the storage triggers all in a stopped state?
Was the event grid resource provider registered against the subscription before the deployment?
That's the usual cause for the triggers not firing.

[flanakin]

+1 on EventGrid. I'm guessing this is because the RP wasn't registered ahead of time.