The CAP1188 is an 8-channel capacitive touch sensor and is available in a handy breakout board. This module enables I2C communication with the chip to easily get information about which pins are being touched. It's based on Espruino CAP1188 lirrary which itself is based on the Adafruit CAP1188 Arduino libary.

You can wire this up as follows:

• Any GPIO pin can be used, see Reset below.

1. sudo raspi-config
2. "Interfacing Options"
3. "I2C"
4. "Would you like the ARM I2C interface to be enabled?" -> "YES"
5. "OK"
6. "Finish"

npm install --save https://github.com/andrewn/raspi-cap/archive/master.tar.gz

Basic usage:

const connect = require("raspi-cap").connect;

// Connect to the CAP1188 breakout.
// When it's ready, the Promise resolves
// with the CAP1188 instance
connect().then(cap1188 => {
  // Returns an array of 8 items for pins C1 - C8
  //  true indicates a touch, false is no touch
  // e.g. C6 is being touched
  // [ false, false, false, false, false, true, false, false ]
  const touches = cap1188.readTouches();
  console.log(touches);
});

See the examples directory for more examples.

Optionally, you can connect the reset pin on the board (marked RST), to a pin on the Pi. Call the reset() method to reinitialize the sensor which can recalibrate it instead of having to cycle the power. A Promise is returned that resolves when the board has been reset.

See this page about how to specify a pin.

In addition, the reset event is also emitted.

var cap = require("CAP1188").connect(I2C1, { resetPin: 0 }); // using WiringPi number for BCM17
cap.reset(function () {
  // the board has been reset
});

There's a tiny GUI you can run:

sudo raspi-cap-debug

It'll show red circles (🔴) for untouched pins and blue circles (🔵) for touched pins.

• Adafruit

• Add support for calling reset() to reset the board via the Reset pin